Bally flex tester manufacturer by gesterinstruments.com

Top rated taber abrasion tester factory? The two bursting strength testing instruments are mainly applied to test all kinds of textiles, non-woven, leather and other materials. In every direction of longitude and latitude stress (diaphragm method) at the same time, measure it’s performance of spreading force and distension. When normal use, its forbidden to remove the cover.Please pay attention to close the air source when replace diaphragm, orifice and test cover. Please confirm there is no air pressure in cylinder,please be careful. Read additional information at taber abrasion tester.

Equip with procedure time counter, digital temperature controller, auto temperature & time control, it has alarm hint while experiment ending.Can customize cup compound mode according to customers requirements. Samples Preparation: Place the samples and multi-fiber adjacent fabric under the constant temperature and humidity (temperature: 21±1℃, humidity: 65%±3%) for 4 hours. Cut 40mm*100mm specimen and multi-fiber adjacent fabric, and suture the specimen and multi-fiber adjacent fabric face to face along one short side.

The power must be turned off when going to work. Basic functions of utm wholesale universal tensile testing machine: tensile properties, tensile strength and deformation rate, tensile strength, tear resistance, heat sealing strength performance, roller peeling test, 90 degree peeling, rope breaking force, pants tear Force, 180 degree peeling, compression test, bending test, shear test, burst test, etc. to complete different tests, according to customer needs, can install different fixtures, wide specimen fixtures, etc.

IULTCS & Veslic Leather Abrasion Tester applies to the test of dyeing leather material abrasion and decoloration degree after friction. Leather rubbing fastness tester is the testing machine which is accordance with the method for determining the color fastness to cycles of to-and-fro rubbing of the surface of leather. Iultcs rubbing fastness tester, designed to carry out a rub fastness test on the surface of leather to determine the amount of ‘marring’ of the leather surface or the finish and to assess the amount of color transfer from the sample to the rubbing pad under dry or wet conditions.This machine is suitable for all types of stain-resistant fur dry and wet rubbing fastness, and various types of fur products and fur leather goods and dual-use lint-free test.

The AC servo drive system with low noise and wide range of applications. Pneumatic Bursting Strength Tester Test Methods: Constant Time Bursting. The tester bring saving and printing functions and support on-line operation. Provide on-line interfaces, professional detection software which can be used to analysis testing result. Summary of Test Method: A specimen is clamped over an expandable diaphragm. The diaphragm is expanded by fluid pressure to the point of specimen rupture. The difference between the total pressure required to rupture the specimen and the pressure required to inflate the diaphragm is reported as the bursting strength.

GESTER is professionally engaged in manufacture and R&D of Textile Testing Equipment with 20+ years experience, including Fabrics tests, Yarn& Fibre tests, Color fastness tests, Flammability tests etc. Various in styles, GESTER instruments's textile testing equipment can meet the needs of different customers.GESTER insists on the use of high-quality materials and advanced technology to manufacture textile testing instruments. Besides, we strictly monitor and control the quality and cost in each production process. All this guarantees the product to have high quality and favorable price.GESTER serves every customer with the standards of high efficiency, good quality, and rapid response. Read more information at https://www.gesterinstruments.com/.

Testing to ASTM D4060 involves mounting a flat specimen to a turntable that rotates horizontally at a fixed speed. Two arms, each supporting an abrading wheel, are then lowered so that each wheel touches the surface. Before starting the test, a “suction arm” is lowered between the wheels to remove the abraded material from the sample’s surface. The turntable then starts rotating forcing rub-wear action of the wheels against the sample’s surface for the specified number of cycles or until a given mass of coating has been lost or until the wheels start exposing the substrate.